HOW TO USE THIS MANUAL
2016 – MX-5 – General Information
HOW TO USE THIS MANUAL
Efficient Replacement of Body Panels
-
This section contains information on the body panels in regard to the welding types, number of spot welds, and cut–and–join locations that are necessary for panel removal and installation.
-
The type of weld and position are indicated by symbols.
-
Some sections have notes concerning the operation being performed. Thoroughly read and understand the notes before carrying out any procedures.
Example
Symbols of Panel Replacement
-
The following 6 symbols are used to indicate the type of weld that is used when replacing body panels.
Body Dimensions (Flat–plane Dimensions)
-
Flat–plane dimensions are the dimensions measured by projecting certain reference points onto a plane surface.
-
When there are no specific indications, the standard points and dimensions are symmetrical in regard to the center of the vehicle.
-
The hypothetical lines may differ according to the vehicle model.
-
The schematic diagram shows the vehicle as it is projected from the underbody.
Example
Body Dimensions (Straight–line Dimensions)
-
Straight–line dimensions are the actual dimensions between two standard points.
-
When there are no specific indications, the standard points and dimensions are symmetrical in regard to the center of the vehicle.
Example
Symbols of Body Dimensions
-
The following 8 symbols are used to indicate the standard points.
