REAR OIL SEAL REPLACEMENT [SKYACTIV-G 2.0]
2016 – MX-5 – Engine
REAR OIL SEAL REPLACEMENT [SKYACTIV-G 2.0]
1. Remove the transmission. (See TRANSMISSION REMOVAL/INSTALLATION [M66M-D] (MT).) (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [SJ6A-EL] (AT).)
2. Remove the flywheel (MT) or drive plate (AT). (See CLUTCH UNIT REMOVAL/INSTALLATION (MT).) (See DRIVE PLATE REMOVAL/INSTALLATION [SJ6A-EL] (AT).)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
|
1 |
Rear oil seal (See Rear Oil Seal Removal Note.) |
Rear Oil Seal Removal Note
1. Remove the rear oil seal lip using a utility knife.
2. Using a screwdriver wrapped in a cloth, remove the rear oil seal being careful not to damage the sealing surface.
Rear Oil Seal Installation Note
1. Apply clean engine oil to the inner surface of a new rear oil seal.
2. Insert the rear oil seal into the cylinder block by hand.
3. Tap the oil seal in evenly using the SST and a hammer.
-
Rear oil seal press on amount C
-
0—0.5 mm {0—0.019 in} from cylinder block