DTC

C0062:28

Longitudinal-G signal

C0062:54

C0062:64

DETECTION CONDITION

• C0062:28

• Longitudinal-G sensor signal outside of specified value.

• C0062:54

• No longitudinal-G sensor initialization is detected.

• C0062:64

• Difference between longitudinal-G calculated by each sensor and longitudinal-G received from low-G sensor outside of specified value is detected.

FAIL-SAFE FUNCTION

• Refer to “Fail-safe function table”. (See DTC TABLE [DSC HU/CM].)

POSSIBLE CAUSE

• The initialization procedure for the low-G sensor has not been performed

• SAS control module malfunction

• DSC HU/CM malfunction

SYSTEM WIRING DIAGRAM

—

Step

Inspection

Action

1

• Has the low-G sensor initialization procedure been performed?

Yes

Go to the next step.

No

Perform the low-G sensor initialization procedure, then go to the next step.

(See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE.)

2

• Using the M-MDS, perform the SAS control module DTC inspection.

  (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

  (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

(See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].)

DTC troubleshooting completed, then go to the next step.

No

Go to the next step.

3

• Using the M-MDS, clear the DTC from the DSC HU/CM.

  (See CLEARING DTC [DSC HU/CM].)

• Using the M-MDS, perform the DSC HU/CM DTC inspection.

  (See DTC INSPECTION [DSC HU/CM].)

• Is the same DTC present?

Yes

Repeat the inspection from Step1

If the malfunction recurs, replace the DSC HU/CM, then go to the next step.

(See DSC HU/CM REMOVAL/INSTALLATION.)

No

Go to the next step.

4

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [DSC HU/CM].)

No

DTC troubleshooting completed.