PARKING BRAKE LEVER REMOVAL/INSTALLATION
2016 – MX-5 – Brakes
PARKING BRAKE LEVER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Selector lever knob (with AT vehicles) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)
b. Shift lever knob (with MT vehicles) (See TRANSMISSION REMOVAL/INSTALLATION [M66M-D].)
c. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)
d. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
e. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION.)
f. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. After installation, inspect the parking brake lever stroke. (See PARKING BRAKE LEVER INSPECTION.)
|
1 |
Parking brake switch connector |
|
2 |
Adjusting nut |
|
3 |
Bolt (See Bolt Installation Note.) |
|
4 |
Parking brake lever |
|
5 |
Bolt |
|
6 |
Parking brake switch |
Bolt Installation Note
1. Tighten the bolt A to the specified torque.
-
Tightening torque
-
26—35 N·m {2.7—3.5 kgf·m, 20—25 ft·lbf}
2. Tighten the bolt B to the specified torque.
-
Tightening torque
-
26—35 N·m {2.7—3.5 kgf·m, 20—25 ft·lbf}