ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [TCM (SJ6A-EL)]
2016 – MX-5 – Transmission/Transaxle
ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [TCM (SJ6A-EL)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
a. Select “Data Logger”.
b. Select “Modules”.
c. Select “TCM”.
3. Select the simulation items from the PID table.
4. Perform the active command modes function, inspect the operations for each part.
-
If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.
Simulation item table
|
Item |
Output part name |
Unit/Condition |
Operation condition |
|
SLT |
Line pressure control solenoid |
A |
Ignition is switched ON (engine off or on) |
|
SS_ON-OFF1 |
Shift solenoid A |
Off/On |
Ignition is switched ON (engine off or on) |
|
SS_ON-OFF2 |
Shift solenoid B |
Off/On |
Ignition is switched ON (engine off or on) |
|
SS_ON-OFF3 |
Shift solenoid C |
Off/On |
Ignition is switched ON (engine off or on) |
|
SS_ON-OFF4 |
Shift solenoid D |
Off/On |
Ignition is switched ON (engine off or on) |
|
SS_ON-OFF5 |
Shift solenoid E |
Off/On |
Ignition is switched ON (engine off or on) |
|
SSA_CC |
Shift solenoid F |
A |
Ignition is switched ON (engine off or on) |
|
SSB_CC |
Shift solenoid G |
A |
Ignition is switched ON (engine off or on) |
|
SSLU_C |
TCC control solenoid |
A |
Ignition is switched ON (engine off or on) |
|
TCC_DC |
TCC control solenoid |
— |
Ignition is switched ON (engine off or on) |