ANTENNA FEEDER NO.1 REMOVAL/INSTALLATION
2016 – MX-5 – Body and Accessories
ANTENNA FEEDER NO.1 REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Scuff plate (passenger’s side) (See SCUFF PLATE REMOVAL/INSTALLATION.)
b. Front side trim (passenger’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
c. A-pillar trim (passenger’s side) (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
d. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)
e. Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)
f. Meter hood (See METER HOOD REMOVAL/INSTALLATION.)
3. Remove the duct and side duct.
4. Disconnect the connector.
5. Remove clips in the position shown in the figure.
6. Remove antenna feeder No.1.
7. Install in the reverse order of removal.