Step

Inspection

Action

1

VERIFY MALFUNCTION (TNS SIGNAL CONDITION)

• Display the instrument cluster PID I_ILLUMI_M item using the M-MDS.

  (See PID/DATA MONITOR INSPECTION [INSTRUMENT CLUSTER].)

• Is the PID On (Night) indicated when the light switch is in the TNS position?

Yes

Go to Step 3.

No

Go to the next step.

2

INSPECT LIGHT SWITCH

• Inspect the light switch.

  (See LIGHT SWITCH INSPECTION.)

• Is the light switch normal?

Yes

Perform the DTC inspection for the start stop unit, instrument cluster and the blind spot monitoring (BSM) control module.

(See DTC INSPECTION [START STOP UNIT].)

(See DTC INSPECTION [INSTRUMENT CLUSTER].)

(See DTC INSPECTION [BLIND SPOT MONITORING (BSM) CONTROL MODULE].)

No

Replace the light switch.

(See LIGHT SWITCH REMOVAL/INSTALLATION.)

3

VERIFY MALFUNCTION (BRIGHTNESS CONDITION)

• Display the following blind spot monitoring (BSM) system PIDs and simulation items using the M-MDS:

  (See PID/DATA MONITOR INSPECTION [BLIND SPOT MONITORING (BSM) CONTROL MODULE].)

  (See ACTIVE COMMAND MODES INSPECTION [BLIND SPOT MONITORING (BSM) CONTROL MODULE].)

PID

• OP_BRT_R

• OP_BRT_L

Simulation item

• WRN_IND_R

• WRN_IND_L

NOTE:

• If the blind spot monitoring (BSM) indicator light was turned on by the simulation function, the blind spot monitoring (BSM) indicator light luminosity becomes 92%.

• Does the PID value indicate 92% when the simulation item is turned on?

Yes

NOTE:

• If the blind spot monitoring (BSM) system is operating normally, the luminosity of the blind spot monitoring (BSM) indicator light will change according to the light switch condition.

• Light switch in TNS position: 70%

• Light switch in position except TNS: 92%

Explain to the customer that the system is normal.

No

Replace the blind spot monitoring (BSM) control module (LH).

(See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION.)