DOOR LOCK-LINK SWITCH INSPECTION
2016 – MX-5 – Body and Accessories
DOOR LOCK-LINK SWITCH INSPECTION
LH
1. Fully close the door glass.
2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
3. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Door key cylinder (See DOOR KEY CYLINDER REMOVAL/INSTALLATION.)
d. Inner handle (See INNER HANDLE REMOVAL/INSTALLATION.)
e. Door latch and lock actuator (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)
4. When the door lock knob cable is pulled or pressed in, verify that the continuity is as indicated in the table.
-
If not as indicated in the table, replace the door latch and lock actuator. (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)
RH
1. Fully close the door glass.
2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
3. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Inner handle (See INNER HANDLE REMOVAL/INSTALLATION.)
d. Door latch and lock actuator (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)
4. When the door lock knob cable is pulled or pressed in, verify that the continuity is as indicated in the table.
-
If not as indicated in the table, replace the door latch and lock actuator. (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)