2016 – MX-5 – Engine

DRIVE SELECTION SWITCH INSPECTION [SKYACTIV-G 2.0]

Resistance Inspection

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the drive selection switch. (See DRIVE SELECTION SWITCH REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

3. Measure the resistance between drive selection switch terminals B and C under the following conditions.

Resistance when drive selection switch pressed to SPORT side (forward) and held

• 0 ohms

Resistance when drive selection switch pressed to — side (backward) and held

• 465.3—474.7 ohms

Resistance when any switch not pressed

• 2643.3—2696.7 ohms

• If not within the specification, replace the drive selection switch. (See DRIVE SELECTION SWITCH REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

< Previous Next >