HAZARD WARNING SWITCH INSPECTION
2016 – MX-5 – Body and Accessories
HAZARD WARNING SWITCH INSPECTION
Continuity Inspection
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Passenger-side scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)
b. Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
c. Passenger-side A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
d. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)
e. Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)
f. Hazard warning switch (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)
3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table.
-
If not as indicated in the table, replace the hazard warning switch. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)
LED Illumination Inspection
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Passenger-side scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)
b. Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
c. Passenger-side A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
d. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)
e. Center panel No.2 (See CENTER PANEL No.2 REMOVAL/INSTALLATION.)
f. Hazard warning switch (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)
3. Apply battery voltage to hazard warning switch terminal A, and connect terminal B to ground.
4. Verify that the LED is turned on.
-
If the LED does not turn on, replace the hazard warning switch. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)