Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM]

< Previous Next >

2016 – MX-5 – Restraints

DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM]

WARNING:

1. Point the upper side of the driver-side air bag module towards the steering wheel as shown in the figure.

2. Connect the horn switch connector.

3. Connect the driver-side air bag module connector and press in the locking device.

4. Move the driver-side air bag module in the direction of the arrow.

5. Rotate the driver-side air bag module clockwise 180 degrees.

6. Lift the driver-side air bag module wiring harness in the direction of the arrow shown in the figure.

7. Align the driver-side air bag module holes with the steering wheel tabs.

8. Press the driver-side air bag module in the direction of the arrow shown in the figure and attach the tabs.

CAUTION:

  • If the driver-side air bag module is installed with the wiring harness contacting the steering wheel tabs, the wiring harness may be damaged. Carefully install the driver-side air bag module while verifying that the wiring harness does not contact the tabs.

9. Verify that the driver-side air bag module is securely installed.

10. Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

11. Switch the ignition ON (engine off or on).

12. Verify that the air bag/seat belt pre-tensioner system warning light illuminates for approx. 6 s and turns off.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.