VELOSTER(FS) >2013 > G 1.6 T-GDI > Body Electrical System > Power Door Locks > Power Door Lock Actuators>Repair procedures  
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
3.
Disconnect the 7P connector from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Actuator Inspection
1.
Remove the rear door trim.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
3.
Disconnect the 7P connector from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Release Actuator Inspection
1.
Remove the tailgate trim panel.
(Refer to the BD group - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Front Door Lock Switch Inspection
1.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
3.
Disconnect the 7P connector from the actuator.

4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Rear Door Lock Switch Inspection
1.
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
3.
Disconnect the 7P connector from the actuator.

4.
Check for continuity between the terminals in each switch position according to the table.

Tailgate Open Switch Inspection
1.
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check for continuity between the terminals in each switch position according to the table.