Rear Wiper Motor
| 1. |
Remove the connector from the rear wiper
motor. |
| 2. |
Connect battery positive (+) and negative (-)
cables to terminals 3 and 4
respectively. |
| 3. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
No
|
Description
|
No
|
Description
|
1
|
Battery
|
3
|
Switch
|
2
|
Parking
|
4
|
Ground
|
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the speed
control. |
| 2. |
Stop the motor operation anywhere except at
the off position by disconnecting terminal
3. |
| 3. |
Connect terminals 2 and
3. |
| 4. |
Connect the positive (+) lead from the battery
to terminal 1 and the negative (-) lead to terminal
4. |
| 5. |
Check that the motor stops running at the off
position.
|
| 1. |
Detach the rear wiper head cap
(A).
|
| 2. |
Remove the rear wiper arm & blade (A)
after removing rear wiper arm nut (B).
|
| 3. |
Remove the rear wiper
grommet. |
| 4. |
Open the tailgate then remove the tailgate
trim.
(Refer to the BD group -
"Tailgate") |
| 5. |
Disconnect the rear wiper motor connector (A)
then remove the rear wiper motor (B) after loosening bolts
(3EA).
|
| 1. |
Install the rear wiper motor assembly and the
grommet.
|
Do not reuse the rubber pad if it is
damaged. | |
| 2. |
Install the tailgate trim.
(Refer to the BD group -
"Tailgate") |
| 3. |
Set the rear wiper blade and to the lowest
defogger heat line and tailgate
glass. |
| 4. |
Set the rear washer nozzle on the specified
spray position.
|
| 5. |
Install the rear wiper cap and rear wiper
nut.
Tightening
torque Nut :
9.8 ~ 12.7 N.m (1.0 ~ 1.3 kgf.m, 7.24 ~
9.38 lbf.ft)
| |
