Inspection

1.	Check the hands free remote control switch for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Voice 3 - 4 10.71 kΩ End of call 3 - 4 18.91 kΩ Send 3 - 4 40.91 kΩ

Removal

1.	Disconnect the negative(-) battery terminal.

2.	Remove th driver airbag module. (Refer to the RT group - "Driver airbag(DAB) and clock spring)

3.	Remove the steering wheel. (Refer to the ST group - "Steering column and shaft")

4.	Remove the cover(A) after loosening screws.

5.	Disconnector the left audio switch (A).

6.	Disconnector the right hands free switch and trip switch (A).

7.	Remove the wiring (A) then loosening 5 screws.

8.	Remove the steering wheel remote control switchs assembly (A).

Installation

1.	Install the hands free switch to the steering wheel.

2.	Install the steering wheel cover.

3.	Install the steering wheel.

4.	Reassemble the driver airbag module. Make sure the hands free remote control switch and the airbag module connectors are plugged in properly.