Inspection

1.

Check the audio remote control switch (A) for resistance between connector terminals in each switch position. [LH-AUDIO] [RH-TRIP] [Audio] Switch Connector terminal Resistance (±5%) Seek up 3-5 430 Ω Seek down 3-5 1.11 kΩ Mode 3-5 2.11 kΩ Volume up 3-5 4.61 kΩ Volume down 3-5 6.81 kΩ [Cruise] Switch Connector terminal Resistance (±5%) ON/ OFF 3-4 880 Ω Cancle 3-4 180 Ω SET - 3-4 330 Ω SET + 3-4 550 Ω [Bluetooth + Voice] Switch Connector terminal Resistance (±5%) Voice 3-4 10.71 kΩ End of call 3-4 18.91 kΩ Send 3-4 40.91 kΩ [Trip + Reset] Switch Connector terminal Resistance (±5%) Trip 3-4 2.54 kΩ Reset 3-4 5.54 kΩ

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the driver airbag module. (Refer to the RT group - "Driver airbag module and clock spring")

3.	Remove the steering wheel. (Refer to the ST group - "Steering column & shaft")

4.	Remove the steering wheel cover (A) after loosening 4 screws.

5.	Remove the steering wheel remote control switches connectors. [LH-Audio/ Bluetooth + Voice] [RH-Cruise/ Trip + Reset]

6.	Remove the wiring and loosen 5 screws.

7.	Remove the steering wheel remote control switch assembly (A).

8.	Remove the bluetooth switch and the trip switch (A) after loosening the screws.

Installation

1.	Install the steering wheel remote control switch.

2.	Install the steering wheel cover.

3.	Install the steering wheel.

4.	Install the driver airbag module. Make sure the audio remote control switch and the airbag module connectors are plugged in properly.