| •
|
Removal of the airbag must be performed
according to the precautions/ procedures described
previously. |
| •
|
Before disconnecting the front impact
sensor connector, disconnect the front airbag
connector(s). |
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the front
impact sensor.
| |
| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the front wheel
guard. |
| 3. |
Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer
motor")
[Right side
only] |
| 4. |
Remove the front impact sensor mounting bolt
(B).
|
| 5. |
Disconnect the front impact sensor connector
(A). |
| 6. |
Remove the front impact sensor.
|
| •
|
Do not turn the ignition switch ON and
do not contact the battery cable while replacing the front
impact sensor.
| |
| 1. |
Install the new front impact
sensor. |
| 2. |
Tighten the front impact sensor mounting
bolt.
Tightening
torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~
6.6 lb-ft)
| |
| 3. |
Connect the front impact sensor
connector. |
| 4. |
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer
motor")
[Right side
only] |
| 5. |
Install the front wheel
guard. |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the Front Impact Sensor,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
