| Pressure Side Impact
Sensor |
| •
|
Removal of the airbag must be performed
according to the precautions/procedures described
previously. |
| •
|
Before disconnecting the side impact
sensor connector(s), disconnect the side airbag
connector(s). |
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the side
impact sensor.
| |
| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the front door trim.
(Refer to the Body group - "Front
door") |
| 3. |
Disconnect the pressure side impact sensor
connector (A) and remove the pressure side impact sensor mounting
screws (B).
|
Side Impact Sensor
| 1. |
Disconnect the battery negative cable and wait
for at least three minutes before beginning
work. |
| 2. |
Remove the door scuff trim.
(Refer to the Body group - "Interior
trim") |
| 3. |
Remove the center pillar trim.
(Refer to the Body group - "Interior
trim") |
| 4. |
Disconnect the side impact sensor connector
(A).
|
| 5. |
Loosen the side impact sensor mounting bolt
(B) and remove the side impact
sensor. |
| Pressure Side Impact
Sensor |
| 1. |
Install the new pressure side impact sensor
with the screws (B) then connect the pressure side impact sensor
connector (A).
Tightening
torque :
1.1 ~ 1.3 N.m (0.11 ~ 0.13 kgf.m, 0.81 ~
0.96 lb-ft)
|
| •
|
Use the specified screws
only. | | |
| 2. |
Install the front door trim.
(Refer to the Body group - "Front
door") |
| 3. |
Reconnect the battery negative
cable. |
| 4. |
After installing the pressure side impact
sensor, confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go off. |
| •
|
You must comply with the specified
tightening torques with the tool specified because
Pressure – Side Impact Sensors (P-SIS) may be broken or
POP-NUT may be rotated.
|
| •
|
Problems may be occurred in the
durability of P-SIS or impact sensing performance may be
depreciated if POP-NUT is
rotated. |
| •
|
The door module must not be
transformed because SRSCM judges a impact through the
pressure sensor in the door
module. | | |
Side Impact Sensor
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the side
impact sensor.
| |
| 1. |
Install the new side impact sensor with the
bolt (B) then connect the side impact sensor connector
(A).
Tightening
torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~
6.6 lb-ft)
|
|
| 2. |
Install the center pillar trim.
(Refer to the Body group - "Interior
tirm") |
| 3. |
Install the door scuff trim.
(Refer to the Body group - "Interior
tirm") |
| 4. |
Reconnect the battery negative
cable. |
| 5. |
After installing the Side Impact Sensor,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
