| 1. |
Disconnect the battery negative cable and wait
for at least 3 minutes before beginning
work. |
| 2. |
Remove the roof trim.
(Refer to the Body group -
"Interior") |
| 3. |
Disconnect the curtain airbag harness
connector (A).
|
| 4. |
After loosening the mounting bolts remove the
curtain airbag.
|
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Tighten the curtain airbag mounting bolts.
Tightening
torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~
8.7 lb.ft)
|
| •
|
Never twist the airbag module when
installing it. If the module is twisted, airbag module
may operate
abnormally. | | |
| 4. |
Connect the curtain airbag
connector. |
| 5. |
Install the roof trim.
(Refer to the Body group -
"Interior") |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the curtain airbag (CAB),
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
