| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the seat belt after pushing the lock
pin (A).
|
| 3. |
Remove the following parts.
(Refer to the Body group - "Interior
trim")
|
| 4. |
Remove the upper anchor
bolt. |
| 5. |
Disconnect the seat belt pretensioner
connector (A).
|
| 6. |
Loosen the seat belt pretensioner mounting
bolts (B,C) and remove the seat belt
pretensioner. |
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Install the seat belt pretensioner with a
bolts (B, C).
Tightening
torque [Bolt B]:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft)
|
|
| 4. |
Connect the seat belt pretensioner (BPT)
connector (A). |
| 5. |
Install the upper anchor bolts.
Tightening
torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft)
| |
| 6. |
Install the following parts.
(Refer to the Body group - "Interior
trim")
|
| 7. |
Insert seat belt to the anchor
pretensioner.
|
Make sure the lock pin is connected in
properly. | |
| 8. |
Reconnect the battery negative
cable. |
| 9. |
After installing the seat belt pretensioner,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
