| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the seat belt after pushing the lock
pin (A).
|
| 3. |
Remove the following parts.
(Refer to the Body group - "Interior
trim")
|
| 4. |
Disconnect the anchor pretensioner connector
(A).
|
| 5. |
Loosen the anchor pretensioner mounting bolt
(B) and remove the anchor
pretensioner. |
| 1. |
Remove ignition key from the
vehicle. |
| 2. |
Disconnect the negative (-) cable from battery
and wait for at least three
minutes. |
| 3. |
Install the anchor pretensioner with mounting
bolt.
Tightening
torque :
39.2 ~ 53.9 N.m(4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft)
| |
| 4. |
Connect the anchor pretensioner
connector. |
| 5. |
Install the following parts.
(Refer to the Body group - "Interior
trim")
|
| 6. |
Insert the seat belt to the anchor
pretensioner (A).
|
Make sure the lock pin is connected in
properly. | |
| 7. |
Reconnect the battery negative
cable. |
| 8. |
After installing the anchor pretensioner,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
