|
The side airbag cannot be disassembled from
the seat back assembly, so replace assembly when replacing the side
airbag.
|
| 1. |
Disconnect the battery negative cable and wait
for at least 3 minutes before beginning
work. |
| 2. |
Remove the front seat assembly.
(Refer to the Body group -
"Seat") |
| 3. |
Remove the seat back assembly.
(Refer to the Body group -
"Seat") |
|
Be sure to install the harness wires not to be
pinched or interfered with other
parts. |
| •
|
Do not open the lid of the side airbag
cover. |
| •
|
Make sure that the airbag assembly cover
is installed properly. Improper installation may prevent the
proper deployment.
| |
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Install the new seat back
assembly.
(Refer to the Body group -
"Seat") |
| 4. |
Install the front seat assembly.
(Refer to the Body group -
"Seat") |
| 5. |
Recline and slide the front seat forward
fully, make sure the harness wires are not pinched of interfering
with other parts. |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the side airbag (SAB),
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
