Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the lower anchor bolt.

3.	Remove the following parts. (Refer to the Body group - "Interior trim") A. Door scuff trim B. Center pillar trim

4.	Remove the upper anchor bolt.

5.	Disconnect the seat belt pretensioner connector (A).

6.	Loosen the seat belt pretensioner mounting bolts (B,C) and remove the seat belt pretensioner.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

3.	Install the seat belt pretensioner with a bolts (B, C). Tightening torque [Bolt B]: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the seat belt pretensioner (BPT) connector (A).

5.	Install the upper anchor bolts. Tightening torque: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.	Install the following parts. (Refer to the Body group - "Interior trim") A. Center pillar trim B. Door scuff trim

7.	Install the lower anchor bolts. Tightening torque: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

8.	Reconnect the battery negative cable.

9.	After installing the seat belt pretensioner, confirm proper system operation: A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.