Replacement

• When installing the belt, make sure not to damaged the pretensioner.

1.	Remove the following items first : A. Front seat assembly (Refer to the BD group - "Front Seat") B. Front door scuff trim (Refer to the BD group - "Interior Trim") C. Rear door scuff trim [RH] (Refer to the BD group - "Interior Trim")

2.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

3.	The seat belt anchor pretensioner (A) be removed after pushing the lock pin (B) as arrow direction. [LH] [RH]

4.	Using a screwdriver or remover, remove the center pillar lower trim (A). [LH] [RH]

5.	Using a screwdriver or remover, remove the front seat belt upper anchor cover (A). [LH] [RH]

6.	After loosening the mounting bolt, then remove the front seat belt upper anchor (A). [LH] Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft ) [RH] Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

7.	After loosening the mounting bolt, then remove the center pillar upper trim (A). [LH] [RH]

8.	After disconnecting the pretensioner connector lock pin, remove the seat belt pretensioner connector (A), loosen the mounting bolts, then remove the pretensioner (B). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

9.	Installation is the reverse of removal. • Make sure the connector is plugged in properly. • Replace any damage clips.

1.	Remove the following items first : A. Front seat assembly (Refer to the BD group - "Front Seat")

2.	After loosening the mounting screws, then remove the front seat track side cover (A).

3.	Remove the seat belt buckle connector mounting clip (A).

4.	After loosening the mounting bolt, then remove the front seat belt buckle (A). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

5.	Installation is the reverse of removal. • Replace any damage clips.