| 1. |
Drain the brake fluid through the bleed plug
(A).
|
| 2. |
Remove the clutch release cylinder assembly
(C) after removing thd tube (B) and nuts (A-2ea).
Tightening
torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~
15.9 lb-ft)
|
|
| 1. |
Installation is the reverse of removal.
|
Coat the clutch clevis push rod
specified grease. |
Specified
grease: CASMOLY
L9508
|
|
| Clutch Release
Cylinder Air Bleeding Procedure |
|
Use the specified fluid. Avoid mixing
different brands of fluid. |
Specified
fluid: SAE J1703 (DOT 3 or DOT 4)
|
| 1. |
After disconnecting a cap from the clutch
release cylinder air bleeder, insert a vinyl hose in the plug.
|
| 2. |
Loosening the plug screw, press and release
the clutch pedal about 10 times. |
| 3. |
Tighten the plug (A) during the clutch pedal
pressed. Afterwards, raise the pedal with a hand.
|
| 4. |
After pressing the clutch pedal 3 times more,
loosen the plug (A) and retighten it with the pedal pressed. Raise
it again, then. |
| 5. |
Repeat the step 4 two or three times. (until
there is no bubble in the fluid)
Tightening
torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 9.2 ~
13.3 lb-ft)
|
|
| 6. |
Refill the clutch master cylinder with the
specified fluid. |
|
