| 1. |
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual
Transaxle") |
| 2. |
Remove the concentric slave cylinder assembly
from the transaxle case by removing bolts (A).
Tightening
torque:
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~
19.5 lb-ft)
|
|
| •
|
Install the concentric slave cylinder
bolts. Not to be bent or twisted, Tighten them in diagonal
directions. |
| •
|
When it is assembled, it must be free
from invasive foreign matters and oil leakage.
| |
| 1. |
Installation is in reverse order of removal.
|
| 2. |
Perform bleeding air procedure in concentric
slave cylinder after pouring the brake fluid.
(Refer to Concentric Slave Cylinder Assembly -
"Adjustment") |
| Concentric Slave
Cylinder Air Bleeding Procedure |
| 1. |
After disconnecting a cap from the concentric
slave cylinder air bleeder, insert a vinyl hose in the
plug. |
| 2. |
Refill the reservoir tank with the specified
fluid.
|
Use the specified fluid. Avoid mixing
different brands of fluid.
Specified fluid: SAE J1703 (DOT 3
or DOT 4)
| | |
| 3. |
Pump the clutch pedal about 10
times. |
| 4. |
Loosen the air bleed screw (A) at hold down
the clutch pedal to allow air to escape from the clutch system. Then
tighten the air bleed screw.
|
| 5. |
Repeat the step 2 ~ 4 until there is no bubble
in the
fluid. | |
