| 1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is
securely supported. |
| 2. |
Remove the rear wheel and tire (A) from rear
hub .
Tightening
torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0
~ 79.5 lb-ft)
|
|
Be careful not to damage to the hub
bolts when removing the rear wheel and tire
(A). | |
| 3. |
Remove the clip (A) and then remove the
parking brake cable (B).
|
| 4. |
Remove the brake caliper mounting bolts, and
then place the brake caliper assembly (A) with wire.
Tightening
torque:
63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~
54.2 lb-ft)
|
|
| 5. |
Loosen the mounting screws and then brake disc
(A).
Tightening
torque:
4.9 ~ 5.8 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~
4.3 lb-ft)
|
|
| 6. |
Loosen the hub mounting bolt and then remove
the hub (A) from torsion beam axle.
Tightening
torque:
49.0 ~ 58.8 N.m (5.0 ~ 6.0 kgf.m, 36.1 ~
43.3 lb-ft)
|
|
| 7. |
Install in the reverse order of
removal. |
| 1. |
Check the hub for cracks and the splines for
wear. |
| 2. |
Check the brake disc for scoring and
damage. |
| 3. |
Check the rear axle carrier for
cracks |
| 4. |
Check the bearing for cracks or
damage. | |
