| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Remove the intake manifold (Refer to “Intake
And Exhaust System” in EM group). |
| 3. |
Disconnect the injector connector
(A). |
| 4. |
Remove the installation bolt (B), and then
remove the sensor from the cylinder block.
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
| |
| 1. |
Installation is reverse of
removal.
Knock sensor
installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~
17.4 lb-ft)
| | |
