| 1. |
Turn the ignition switch
OFF. |
| 2. |
Disconnect the HO2S
connector. |
| 3. |
Measure resistance between the HO2S terminals
2 and 5 [B1/S1]. |
| 4. |
Measure resistance between the HO2S terminals
3 and 4 [B1/S2]. |
| 5. |
Check that the resistance is within the
specification.
Specification: Refer to
“Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Disconnect the connector (A), and then remove
the sensor (B).
|
Note that the SST (Part No.:
09392-1Y100) is useful when removing the heated oxygen
sensor. |
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Remove the console side cover
(A).
|
| 3. |
Disconnect the connector (A).
|
| 4. |
Remove heated oxygen sensor (A).
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before
installing. | |
| •
|
DON’T use a cleaner, spray, or grease to
sensing element and connector of the sensor because oil
component in them may malfunction the sensor
performance. |
| •
|
Sensor and its wiring may be damaged in
case of contacting with the exhaust system (Exhaust Manifold,
Catalytic Converter, and so on).
| |
| 1. |
Installation is reverse of
removal.
Heated oxygen
sensor installation:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~
36.2 lb-ft)
| | |
