| 1. |
Turn the ignition switch
OFF. |
| 2. |
Disconnect the PCSV
connector. |
| 3. |
Measure resistance between the PCSV terminals
1 and 2. |
| 4. |
Check that the resistance is within the
specification.
Specification: Refer to
“Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Disconnect the purge control solenoid valve
connector (A). |
| 3. |
Disconnect the vapor hoses (B) from the purge
control solenoid valve. |
| 4. |
Remove the installation bolt (C), and then
remove the PCSV (D) from the engine.
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before
installing. | |
| •
|
Use care to keep foreign material out of
the valve.
| |
| 1. |
Installation is reverse of
removal.
Purge control
solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
| | |
