Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the RCV connector.

3.	Measure resistance between the RCV terminals 1 and 2.

4.	Check that the resistance is within the specification. Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the air duck (A).

3.	Disconnect the cooling pan control connector (A) and cooling pan & RCV extension connector (B) from the bracket.

4.	Disconnect the RCV control solenoid valve connector (A) and vapor hoses (B).

5.	Remove the installation bolts (C) and then RCV control solenoid valve (D).

Installation

• Install the component with the specified torques. • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Installation is reverse of removal. RCV control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)