Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the ATS connector.

3.	Measure resistance between the ATS terminals 1 and 2 [B1/S1].

4.	Check that the resistance is within the specification. Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the Ambient Temperature Sensor connect (A).

3.	Remove the Ambient Temperature Sensor bracket (B).

Installation

• Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Installation is reverse of removal.