VELOSTER(FS) >2013 > G 1.6 T-GDI > Engine Electrical System > Ignition System > Ignition Coil>Repair procedures  
Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).

When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Installation
1.
Install in the reverse order of removal.

Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).


Standard value: 0.79Ω ± 15%