Engine Mechanical System > Cylinder Block > Rear Oil Seal > Repair procedures

VELOSTER(FS) >2013 > G 1.6 T-GDI > Engine Mechanical System > Cylinder Block > Rear Oil Seal>Repair procedures

Removal

1.	Remove the transaxle assembly. (Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")

2.	MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel")

3.	AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Remove the rear oil seal(A).

Installation

1.

Install the rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.	MT : Install the flywheel. (Refet to Cylinder Block - "FlyWheel")

3.	AT : Install the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Install the transaxle assembly. (Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")