VALVE SEAT INSPECTION/REPAIR
VALVE SEAT INSPECTION/REPAIR
SM1665864
id011000501300
1.Measure the contact width of the valve face and the valve seat using the valve lapping compound.
-
• If it is not within the specification, resurface the valve seat using the 45° valve seat cutter.
bpe2ue00000028
|
-
Standard valve seat contact width
-
1.37—1.84 mm {0.0540—0.0724 in}
-
Valve seat angle
-
45°
2.Verify that the area where the valve seat contacts the valve face is centered.
-
• If the seating position is too high, correct the valve seat using a 70° (IN) 70° (EX) valve seat cutter and a 45° valve seat cutter.
-
• If the seating position is too low, correct as follows:
-
― IN: Correct the valve seat using a 20° valve seat cutter and then using a 45° valve cutter.― EX: Correct the valve seat using a 45° valve seat cutter.
-
bpe2ue00000201
|
3.Inspect the valve seat for sinkage. Measure the protruding length (dimension L) of the valve stem using a valve of standard length.
-
• If it is not within the specification, replace the cylinder head.
bp31je00000051
|
-
Standard valve seat sinkage amount (Dimension L)
-
IN: 49.03—50.27 mm {1.931—1.979 in}EX: 49.03—50.27 mm {1.931—1.979 in}