Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

CYLINDER BLOCK INSPECTION

CYLINDER BLOCK INSPECTION

SM2841622


id011000507200

1.Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.

bp31je00000144
• If it exceeds the maximum specification, replace the cylinder block.
Maximum distortion, head gasket side of the cylinder block
0.10 mm {0.0039 in}

2.Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 43.9 mm {1.73 in} below the top surface of the cylinder as shown in the figure.

bpe2ue00000098
• If it is not within the specification, replace the cylinder block.
Standard cylinder bore diameter
89.000—89.030 mm {3.5040—3.5051 in}