FRONT RADAR SENSOR [(US)]
FRONT RADAR SENSOR [(US)]
SM2565508
id1511000060a3
Purpose
-
― Mazda radar cruise control (MRCC) system― Mazda radar cruise control with stop & go function (MRCC WITH STOP & GO FUNCTION)― Smart brake support (SBS) system― Distance & speed alert (DSA) system― Traffic Jam Assist (TJA) system
Functions
-
Note
-
• Under the following conditions, the front radar sensor may not be able to detect vehicles ahead or obstructions correctly and each system may not operate normally.
-
― The rear surface of a vehicle ahead does not reflect radio waves effectively, such as an unloaded trailer or an automobile with a loading platform covered by a soft top, vehicles with a hard plastic tailgate, and round-shaped vehicles.― Vehicles ahead with low vehicle height and thus less area for reflecting radio waves.― Visibility is reduced due to a vehicle ahead casting off water, snow, or sand from its tires and onto your windshield.― The luggage compartment is loaded with heavy objects or the rear passenger seats are occupied.― Ice, snow, or dirt is on the front surface of the front emblem.― During inclement weather such as rain, snow, or sand storms.― When driving near facilities or objects emitting strong radio waves.
• Under the following conditions, the front radar sensor may not be able to detect vehicles ahead or obstructions.-
― The beginning and end of a curve.― Roads with continuous curves.― Narrow lane roads due to road construction or lane closures.― The vehicle ahead enters the radar unit’s blind spot.― The vehicle ahead is driving abnormally due to accident or vehicle damage.― Roads with repeated up and down slopes.― Driving on poor roads or unpaved roads.― The distance between your vehicle and the vehicle ahead is extremely short.― A vehicle suddenly comes close such as by cutting into the lane.
• If the battery power is weak, the system may not operate correctly. -
|
On-board diagnostic function
-
• The front radar sensor detects internal malfunctions of the front radar sensor and outputs DTCs.
Automatic configuration function
-
• When the ignition is switched ON (engine off or on) for the first time after the front side radar sensor has been replaced, the front side radar sensor reads the specification information sent via CAN communication from the body control module (BCM) and it performs automatic configuration.
Radar emission angle correction function
-
• The front radar sensor corrects deviations in the radar emission angles, caused by installation tolerances after the following procedure is performed, by implementing the radar aiming procedure.
-
― Front radar sensor removal/installation or replacement― Front bumper removal/installation― Mascot removal/installation
• For the front radar sensor aiming procedure, refer to the [FRONT RADAR SENSOR AIMING] in the workshop manual. -
Construction
|
Operation
Target information detection
-
• The front radar sensor emits milimeter waves from the front of the front radar sensor and detects a target object in front of the vehicle (vehicle ahead) by the reflected waves. The front radar sensor calculates the target position, distance from the vehicle, and relative speed based on the reflected waves and detects as target information.