id0116u0819800

Replacement Part

1.Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)])

2.Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)

3.Remove in the order indicated in the table.

4.Install in the reverse order of removal.

SKYACTIV-G 2.0

ac5uuw00003210

SKYACTIV-G 2.5

am6xuw00006515

Retainer Removal Note

Caution

• Be sure to follow the removal procedures below to prevent the leakage of blow-by gas caused by the damage to the tab of the oil separator or the oil separator itself.

1.Insert a flat blade screwdriver with its tip wrapped in a clean cloth into the gap between the retainer and the oil separator as shown in the figure.

am3zzw00036358

2.Spread the side surface of the retainer outward to dismount it with attention to the tab.

Retainer Installation Note

Caution

• Be sure to replace the old retainer with a new one to prevent the escape of blow-by gas. Reinstalling the old retainer will reduce airtightness.

1.Make sure that the retainer alignment mark is directed as shown in the left diagram before installing the retainer to the oil separator.

SKYACTIV-G 2.0

am3uuw00008710

SKYACTIV-G 2.5

am6xuw00006517

PCV Hose Installation Note

SKYACTIV-G 2.0

1.Install the end of the PCV hose on the marking side (PCV hose with smaller inner diameter) to the PCV valve.

ac5uuw00003211

SKYACTIV-G 2.5

1.Install the end of the PCV hose on the marking side (PCV hose with the larger inner diameter) to the PCV valve.

ac5wzw00006461