---

id0213008006x1

LH(ATX)

1.Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)

2.Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3.Remove the front under cover No.1. (See FRONT UNDER COVER No.1 REMOVAL/INSTALLATION.)

4.Remove the gusset.

am3zzw00031427

5.Remove the tunnel cover. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)

6.Remove the front deflector. (See DEFLECTOR REMOVAL/INSTALLATION.)

7.Remove the front splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION.)

8.Disconnect the hanger rubber from the front crossmember and set it aside.

am3zzw00036468

9.Remove the joint cover. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [(US)].)

10.Disconnect the intermediate shaft from the steering gear and linkage. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [(US)].)

11.Disconnect the front lower arm ball joint from the steering knuckle.

am3zzw00035317

12.Remove the No.1 engine mount rubber installation bolts.

am3zzw00036465

13.Lower the front crossmember component approx. 30 mm to the position where the front lower arm installation bolt can be removed.

am3zzw00036466

14.Remove in the order shown in the figure.

15.Install in the reverse order of removal. (See Suspension Links Installation Note.)

16.If the front lower arm component is replaced, inspect the wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT [(US)].)

am3zzw00036467

1	Front lower arm (See Front Lower Arm Installation Note (VIN: 3M*).)
2	Dynamic damper

LH(MTX), RH

1.Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)

2.Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3.Remove in the order shown in the figure.

4.Install in the reverse order of removal. (See Suspension Links Installation Note.)

5.If the front lower arm component is replaced, inspect the wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT [(US)].)

am3zzw00036242

1	Front lower arm ball joint (See Front Lower Arm Ball Joint Installation Note.)
2	Ball joint cover
3	Front lower arm (See Front Lower Arm Installation Note (VIN: 3M*).)
4	Dynamic damper

Suspension Links Installation Note

1.When installing the joint section with a rubber bushing, perform the following steps.

(1)Temporarily tighten the bolt with the vehicle lifted up.

(2)Lower the vehicle to the ground and tighten the bolt to the specified torque.

Front Lower Arm Ball Joint Installation Note

1.Install a ball joint cover to the steering knuckle before installing the front lower arm ball joint.

am3zzw00023023

2.Insert the bolt from the front of the vehicle and tighten the nut to the specified torque.

Front Lower Arm Installation Note (VIN: 3M*)

1.Verify that the inner bushing is correctly assembled to the front crossmember without any gaps before tightening the bolt shown in the figure.

am3zzw00031426

2.Install the front lower arm.