id152000012300

Note

• The front radar sensor aiming procedure stores the installation angle in the front radar sensor by mid-drive aiming, which is performed by transitioning to the aiming mode and driving the vehicle for a predetermined time.

• The front radar sensor aiming cannot be performed correctly if there is an obstruction on the mascot surface. Perform the following procedure before performing the aiming.

― Verify that there is no water, mud, dirt, or a sticker on the surface of the mascot.

• Perform the front radar sensor aiming if any of the following procedure is performed.

― Front radar sensor removal/installation or replacement

― Front bumper removal/installation

― Mascot removal/installation

• Driving the vehicle for a total of 15 min under the following conditions is necessary to complete mid-drive aiming (dynamic aiming). However, driving the vehicle while matching the conditions does not have to be continuous.

― Drive the vehicle at a vehicle speed of 5 km/h {3 mph} or more

― Drive the vehicle on a straight road (road with a turning radius of 100 m {328 ft 1 in} or more)

― Drive the vehicle on a road with structures (guard rail, buildings and signs).

― Drive the vehicle accelerating/decelerating at 2.5 m/s² or less.

• mid-drive aiming (dynamic aiming) may not complete in an environment where any of the following conditions continues.

― Inclement weather caused by snow, rain, or fog

― Vehicle is driven downhill or on extremely rough or uneven roads

― Vehicle is driven through tunnels and over bridges.

Aiming Procedure

1.Empty the vehicle by having all occupants leave the vehicle and remove all the cargo except for the spare tire, jack and tools.

2.Adjust the air pressure of each tire to the specified value. (See WHEEL AND TIRE SPECIFICATION [(US)].)

3.Park the vehicle on level ground.

4.Connect the M-MDS.

5.After the vehicle is identified, select the following items from the initial screen of the M-MDS.

1. “Toolbox”

2. “Work Support”

3. “i-ACTIVSENSE”

4. “Dynamic aiming for Front Rader”

6.Perform the front radar sensor aiming procedure according to the directions on the M-MDS.

7.Drive the vehicle on a road and verify that the message in the multi-information display is no longer displayed.