id091900856500

1.Select [Calibrating Front Wiper position] using the M-MDS.

Note

• When [Calibrating Front Wiper position] is selected, the driver’s windshield wiper blade moves close to the A pillar.

2.Adjust the driver’s windshield wiper arm and blade position using the following procedure.

(1)Lift the driver’s windshield wiper blade by hand and lower it gently.

(2)Verify that the driver’s windshield wiper blade is at the position shown in the figure.

am3zzw00033068

• If the driver’s windshield wiper blade is not at the position shown in the figure, move the driver’s windshield wiper arm by hand and adjust, and then return to Step 2.

3.Turn the light switch off. (With headlight cleaner)

4.Pull the windshield wiper switch 2 times and perform the windshield wiper arm and blade position learning.

Note

• When the windshield wiper arm and blade position learning is completed, the windshield wipers return to their initial positions.

5.Switch the ignition OFF.

6.Verify that DTC B1131:92 is not output.

• If a DTC is detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [BODY CONTROL MODULE (BCM) (US)].)