id0740a18204y1

Warning

• Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. (See AIR BAG SYSTEM SERVICE WARNINGS [STANDARD DEPLOYMENT CONTROL SYSTEM – MEXICO SPEC.].) (See AIR BAG SYSTEM SERVICE CAUTIONS [STANDARD DEPLOYMENT CONTROL SYSTEM – MEXICO SPEC.].) (See AIR BAG SYSTEM SERVICE WARNINGS [TWO-STEP DEPLOYMENT CONTROL SYSTEM – US/CANADA SPEC.].) (See AIR BAG SYSTEM SERVICE CAUTIONS [TWO-STEP DEPLOYMENT CONTROL SYSTEM – US/CANADA SPEC.].)

Caution

• When replacing the dash-electrical supply unit, perform the configuration to assure that the system operates correctly. (See CONFIGURATION.)

1.Disconnect the negative battery terminal and wait for 1 min or more. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)

2.Remove the following parts:

(1)Glove compartment (without passenger-side knee air bag module) (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(2)Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(3)Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(4)Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(5)Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(6)Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION [(US)].)

(7)Passenger-side knee air bag module (with passenger-side knee air bag module) (See KNEE AIR BAG MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM – US/CANADA SPEC.].)

3.Disconnect the connectors.

am3zzw00021406

4.Remove the screws.

am3zzw00027877

5.Remove the dash-electrical supply unit.

6.Install in the reverse order of removal.

7.If the dash-electrical supply unit is replaced, perform the following procedure.

(1)Perform manual configuration using the following procedure.

1)Connect the M-MDS to the DLC-2.

2)Switch the ignition ON (engine off or on).

3)Perform vehicle identification.

4)Select [Configuration] using the M-MDS.

5)Select [DASH_ESU].

6)Perform manual configuration following the instructions on the screen.

(2)Switch the ignition OFF.

(3)Switch the ignition ON (engine off or on) to complete the dash-electrical supply unit automatic configuration.

(4)Clear the DTC. (See CLEARING DTC.)