CYLINDER BLOCK INSPECTION
CYLINDER BLOCK INSPECTION
SM2841702
id011000507200
1.Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.
-
• If it exceeds the maximum specification, replace the cylinder block.
bp31je00000144
|
-
Maximum distortion, head gasket side of the cylinder block
-
0.10 mm {0.0039 in}
2.Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 43.9 mm {1.73 in} below the top surface of the cylinder as shown in the figure.
-
• If it is not within the specification, replace the cylinder block.
btstze00000040
|
-
Standard cylinder bore diameter
-
89.000—89.030 mm {3.5040—3.5051 in}