ONLY PARTIAL INDICATION ON ACTIVE DRIVING DISPLAY [ACTIVE DRIVING DISPLAY]
ONLY PARTIAL INDICATION ON ACTIVE DRIVING DISPLAY [ACTIVE DRIVING DISPLAY]
SM2336295
id0903m7031500
Outline
|
Description
|
• When the ignition is switched ON (engine off or on), there is only partial indication on the active driving display.
|
|
Possible cause
|
• Indication on active driving display is turned off by setting personalization feature
• Active driving display malfunction
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
VERIFY ALL SYSTEM DTCs
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY PERSONALIZATION FEATURES SETTING
• Verify the active driving display indication setting.
• Is the indication setting turned off?
|
Yes
|
Turn on the indication setting and verify the operation.
Operation is verified:
• Troubleshooting completed. (Explain the contents of the servicing to the customer.)
Operation is not verified:
• Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Has the malfunction symptom been eliminated?
|
Yes
|
Complete the symptom troubleshooting. (Explain contents of repair to customer)
|
|
No
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction is not resolved, replace the active driving display. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION [(US)].)
|