WASHER FLUID IS NOT SPRAYED ON REAR GLASS [WIPER/WASHER SYSTEM]
WASHER FLUID IS NOT SPRAYED ON REAR GLASS [WIPER/WASHER SYSTEM]
SM2336315
id0903p6068700
Outline
|
Description
|
• When operating the wiper and washer switch, the washer fluid is not sprayed onto the rear glass.
|
|
Possible cause
|
• Washer tank is empty
• Foreign matter penetrates washer tank
• Windshield washer hose damage
• Wiper and washer switch malfunction
• Instrument cluster malfunction
• BCM malfunction
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
VERIFY ALL SYSTEM DTCs
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY WASHER TANK CONDITION
• Has foreign matter penetrated the washer tank?
|
Yes
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY REAR WASHER HOSE CONDITION
• Is there a damaged location such as a hole in the rear washer hose?
|
Yes
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT WIPER AND WASHER SWITCH FOR MALFUNCTION
• Inspect the applicable part. (See WIPER AND WASHER SWITCH INSPECTION [(US)].)
• Is the part normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
|
5
|
INSPECT INSTRUMENT CLUSTER FOR MALFUNCTION
• Inspect the applicable part. (See INSTRUMENT CLUSTER INSPECTION [(US)].)
• Is the part normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
|
Repair completion verification
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Has the malfunction symptom been eliminated?
|
Yes
|
Complete the symptom troubleshooting. (Explain contents of repair to customer)
|
|
No
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction is not resolved, replace the BCM. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)
|