id091000800900

1.Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)

2.Remove the following parts:

(1)Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(2)Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION [(US)].)

(3)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(4)Trunk side upper trim (5HB) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(5)Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION.)

(6)Rear splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)

(7)Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION.)

Caution

• Remove the rear bumper reinforcement installation nuts using two people, one person supports the rear bumper reinforcement. If all the rear bumper reinforcement installation nuts are removed without supporting the rear bumper reinforcement, it may fall off and be damaged.

3.Remove the nuts shown in the figure.

am3zzw00023206

4.Remove the rear bumper reinforcement in the direction of the arrow shown in the figure.

5.Install in the reverse order of removal.

6.Perform the 360° view monitor system aiming. (with 360° view monitor system) (See 360°VIEW MONITOR SYSTEM AIMING.)

7.Perform the rear side radar sensor aiming adjustment. (with rear side radar sensor) (See FRONT SIDE/REAR SIDE RADAR SENSOR AIMING.)