id091300812100

1.Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)

2.Fold the rear seat back.

3.Remove the following parts:

(1)Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(2)Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION [(US)].)

(3)Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(4)Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(5)Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(6)C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(7)Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

(8)Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION.)

(9)Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(10)Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)

4.Remove the bolts.

am3zzw00024026

5.Remove the rear seat back striker.

6.Install in the reverse order of removal. (See Bolts installation note.)

Bolts installation note

1.Temporarily tighten the bolt (3)

am3zzw00024028

2.Completely tighten the bolts in the order shown in the figure.