id092000815000

Note

• The integrity of the rear mount camera cannot be determined from a single part. When inspecting the rear mount camera, perform the following procedure.

Without 360° view monitor system

1.Connect the M-MDS to the DLC-2.

2.Perform the DTC inspection for the connectivity master unit (CMU) and verify if any DTCs related to the rear mount camera is detected. (See DTC INSPECTION.)

• If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting.(Refer to the [DTC TABLE [CONNECTIVITY MASTER UNIT (CMU)]] in the workshop manual)

With 360° view monitor system

1.Connect the M-MDS to the DLC-2.

2.Perform the DTC inspection for the 360° view monitor control module and verify if any DTCs related to the rear mount camera is detected. (See DTC INSPECTION.)

• If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (US)].)