IDLER DISASSEMBLY/ASSEMBLY [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))]
IDLER DISASSEMBLY/ASSEMBLY [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))]
SM2565619
id0110u0820100
Replacement Part
|
Bolt
Quantity: 1
Location of use: Magnetic clutch
|
-
Note
-
• The idler is only installed to vehicles without A/C.
1.Disassemble in the order indicated in the table.
am3zzw00028420
|
|
1
|
Bolt
|
|
2
|
Pressure plate
|
|
3
|
Shim
|
|
4
|
Snap ring
|
|
5
|
idler pulley
|
|
6
|
Snap ring
|
|
7
|
Stator
|
|
8
|
Idler body
|
2.Assemble in the reverse order of disassembly.
3.Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)
Bolt removal/installation note
1.When removing or installing the bolt, lock the idler pulley against rotation using the following procedure.
-
Caution
-
• When connecting the positive battery terminal to the magnetic clutch connector, use a cable with a female terminal of the correct size. Otherwise, load will be applied to the terminal, resulting in deformation or damage, and poor contact. In addition, the positive battery terminal could disconnect from the connector resulting in a short circuit.
- (1)Apply battery positive voltage to the magnetic clutch terminal and connect the idler body to the ground.
-
am3zzw00024967
- (2)Wrap the drive belt, which is no longer of use, tightly around the idler pulley.
-
am3zzw00024968
- (3)Hold the drive belt in place with pliers.
- (4)Remove/installation the bolt.
2.When installing a new Idler body, replace the recommended bolt.