id0140u0813300

Voltage Inspection

Caution

• If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.

1.Lift up the vehicle.

2.Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3.Connect the voltmeter to neutral sensor terminal C (vehicle wiring harness side).

4.Verify that the neutral sensor voltage is within the standard when the shift lever is shifted with the ignition switched ON (engine off).

• If not as specified, replace the neutral sensor. (See NEUTRAL SENSOR REMOVAL/INSTALLATION [C66M-R (US)].)

am3zzw00034827

Specification

Shift lever is not at neutral position: Approx. 4.5 V or more

Shift lever is at neutral position: Approx. 0.8 V or less