STARTER DOES NOT WORK [ET6A-EL (US)]
STARTER DOES NOT WORK [ET6A-EL (US)]
SM2566147
id0503n21029n5
|
Troubleshooting item |
Starter does not work |
|---|---|
|
Description
|
• Starter does not work even when in P or N position.
|
|
Possible cause
|
1. Wiring harness between TCM terminal J and PCM terminal 2BD malfunction
2. Wiring harness between BCM terminal 4I and LF control unit terminal L malfunction (With advanced keyless entry system)
3. Immobilizer system operating or system malfunction
4. Engine control system malfunction
|
|
System wiring diagram
|
• Not applicable
|
|
Connector diagram
|
• Not applicable
|
Diagnostic procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
INSPECT WIRING HARNESS BETWEEN TCM AND PCM
• Switch the ignition off.
• Disconnect the PCM connector and TCM connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT WIRING HARNESS BETWEEN TCM AND LF CONTROL UNIT
• Disconnect the LF control unit connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between BCM terminal 4I and LF control unit terminal L.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT IMMOBILIZER SYSTEM AND ENGINE CONTROL SYSTEM FOR MALFUNCTION
• Perform the symptom troubleshooting “WILL NOT CRANK”. (See WILL NOT CRANK [SKYACTIV-G (US)].)
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Symptom troubleshooting is completed.
|